Faber Genie M1600 - Manual (Page 98)

96 • Technical Specifications Genie Monochrome Series-GigE Vision Camera
Cleaning the Sensor Window
Even with careful handling, the sensor window may need cleaning. The following steps describe various cleaning
techniques to clean minor dust particles to accidental finger touches.
• Use compressed air to blow off loose particles. This step alone is usually sufficient to clean the sensor window.
Avoid moving or shaking the compressed air container and use short bursts of air while moving the camera in
the air stream. Agitating the container will cause condensation to form in the air stream. Long air bursts will
chill the sensor window causing more condensation. Condensation, even when left to dry naturally, will deposit
more particles on the sensor.
• When compressed air cannot clean the sensor, Dalsa recommends using lint-free ESD-safe cloth wipers that do
not contain particles that can scratch the window. The Anticon Gold 9”x 9” wiper made by Milliken is both
ESD safe and suitable for class 100 environments. Another ESD acceptable wiper is the TX4025 from
Texwipe.
• An alternative to ESD-safe cloth wipers is Transplex swabs that have desirable ESD properties. There are
several varieties available from Texwipe. Do not use regular cotton swabs, since these can introduce static
charge to the window surface.
• Wipe the window carefully and slowly when using these products.
Environment
Ambient Temperature: 0° to 45° C (operation)
0° to 70° C (storage)
Relative Humidity: 5% to 90% non-condensing (operating)
0% to 95% (storage)