FMI (V)G42H/50H - Manual (Page 12)

www.fmiproducts.com 109493-01R 12
opTional gas line insTallaTion
Continued
CAUTION: All gas piping
and connections must be tested
for leaks after the installation
is completed. After ensuring
that the gas valve is on, apply
soap and water solution to all
connections and joints. Bubbles
forming show a leak. Correct
all leaks at once. DO NOT USE
AN OPEN FLAME FOR LEAK
TESTING AND DO NOT OPER-
ATE ANY APPLIANCE IF A LEAK
IS DETECTED. LEAK TESTING
SHOULD BE DONE BY A QUALI-
FIED SERvICE PERSON.
WARNING: Do not oper-
ate an unvented gas log set in
this fireplace with the chimney
removed.
glass door insTallaTion
Figure 20 - Installing Top Door Frame
Top Door Frame
Smoke Shelf
Figure 21 - Installing Bottom Door Frame
Bottom
Door Rail
Ash Box
Center
Brick
Ring
Handle
Screws
If you install a decorative gas appliance
(vented gas log), the decorative gas appliance
must comply with the Standard for Decorative
Gas Appliance for Installation in Solid Fuel
Burning Fireplaces, ANS Z21.60 or Z21.84
and shall also be installed in accordance with
the National Fuel Gas Code, ANSI 7223NFPA
54 latest edition.
WARNING: If the fireplace
has been used for wood burning,
the firebox and chimney must be
cleaned of soot, creosote and ashes
by a qualified chimney cleaner. Cre-
osote will ignite if heavily heated.
WARNING: When using a
decorative vented gas log, the
damper must be removed or per-
manently locked in the fully open
position and the glass doors must
be in the fully open position.
IMPORTANT: Install glass door
frame before installing glass door.
INSTALLING DOOR FRAMES
1. Remove screws from smoke shelf (see
Figure 20).
2. Mount top door frame and secure with
screws removed in step 1.
3. Remove center brick by pulling ring handle
(see Figure 21).
4. Remove ash box.
5. Remove three screws located at front of
firebox (see Figure 21).
6. Align bottom rail mounting holes with
holes at front of firebox and secure with
screws removed in step 5.
7. Place ash box in place. Replace center
brick.