Faria Instruments MG2000 - Manual (Page 11)

Edit Mode
The “Edit” mode is used to adjust or set
the values of numerous functions and
options in the MG2000. The procedure
below specifies the steps to be taken
in the “Edit” mode to adjust / set each
option.
To enter “Edit” mode, press the “Mode”
and “Up” buttons while in “Normal” mode
To return to “Normal” mode, press “Mode”
button once while in “Edit” mode.
Functions that are set or adjusted in the
“Edit” mode:
1. Select Default Screen
2. Reset Fuel Used
3. Set Fuel Tank Full
4. Set Amount of Fuel
5. Organize User Screens
6. Select Gauge Range
7. Select Fuel Sender
8. Select Oil Pressure Sender
9. Select Display Units
10. Select Fuel Tank Size
11. Fuel Tank Calibrate
12. Low Fuel Alarm
13. Software ID and Revision
14. Select Self Test
Instructions – Function LINE DISPLAY
Select “Default Screen.”
1 Select
Default
Screen
2
3
Press and hold the “Up” and “Down” buttons for 2
seconds to select the “Default Screen.”
Press “Up” or “Down” to select another function or
“Mode” to return to “Normal” mode.
(Display Screen 1 is the “Default” at first turn on.)
1 Display
Screen
1
2
3
Press and hold the “Up” and “Down” buttons for 2
seconds to select screen 1 as the “Default Screen” and
exit.
Press “Up” or “Down” to select another screen.
Page 7