Fostex CR300 - Manual (Page 20)

20
CR300 <PRB1291-A>
6
When playback of the source is started, the All-track synchro
recording starts.
When the SYNC indicator is flashing (all-track synchro recording standby), or during all-
track synchro recording, if the input signal is interrupted or the source is switched to a
source for which auto synchro recording is not possible, the all-track synchro recording
mode will be canceled and the unit will enter the record-pause mode.
7
C. Automatic finalization recording
This operation automatically performs finalization after an
all-track recording (only S/P DIF). Finalization is the final
process in recording a CD-R or CD-RW disc that is playable
on standard CD players.
However, CD-RW discs, whether finalized or not, can only
be played back on a CD-RW disc player. See page 31 for
details.
1
Load a CD-R or CD-
RW disc containing
a recordable space.
For a disc loading, refer to
page 15.
• After loading the disc, check that
the CD-R or CD-RW indicator
stops blinking and starts to light
steadily.
In case it does not light steadily,
refer to page 42.
2
• The AES/EBU digital input cannot be
recorded with this function.
• The ANALOG input cannot be recorded
with this function.
3
Ensure that the source player is not playing (in stop or pause
mode).
• Confirm the track to be recorded before
recording.
Press the DIGITAL
SYNCHRO button twice.
4
Blinks
• Do not start the playback of the
source player until the SYNC
indicator starts to blink.
• Every time the DIGITAL SYNCHRO
button is pressed, the mode is changed
in order of 1-SYNC
➔ AL-SYNC ➔
Record-pause mode.
Select "AL-SYNC" when all-track
recording is required.
5 The FINALIZE indicator blinks.
Blinks Blinks
Press the FINALIZE
button.
When the source playback standby continues for more than 1
minute during an ALL-TRACK SYNCHRO RECORDING, the
recorder assumes that the recording has stopped and finali-
zation starts automatically.
• It usually takes about 4 minutes until the finalization completes.
• See page 31 for details.
• The finalize-standby mode can be cancelled by pressing the stop ( ) button or FINAL-
IZE button while the unit is in the finalize-standby mode.
• Operating buttons do not respond when finalization has begun.
• Operation stops automatically without performing finalization when no more recording
time remains or when there are 99 or more tracks.
Label side
Wait until the SYNC indicator blinks.
AUTOMATIC DIGITAL-SOURCE SYNCHRO RECORDING
• Never turn off the power during
finalization!
• Press the FINALIZE button once again
so that the FINALIZE indicator goes
out; the Automatic Finalization will not
occur (mode will revert to All-track
synchro).
4 2 1
5
ANALOG DIGITAL
INPUT SELECTOR
OPT
AES /
EBU
LINE
COAX XLR / -10
XLR / +4
•
•
•
•
•
•
Set the INPUT SELECTOR
to DIGITAL.
Select OPTICAL or COAXIAL.
• C h e c k t h e c o p y b i t
indicator(refer to page 24).
• This function cannot be activated if the source is being played.
• The source unit stops playback
and after no signal(less than -
90dB) condition lasts for the
length set by the MENU button
functions(see page 24), the unit
reverts to the status noted in step
4 and "AL-SYNC" is displayed
again.
Be careful not to restart playback
of the source player under this
condition, for this will start the
recording again.