Fostex CR300 - Manual (Page 25)

25
CR300 <PRB1291-A>
D. Automatic Track Number Renewal Level Sensitivity Setting
This menu selects the analog source input level sensitivity for automatic track number renewal. (Refer to page 22, 26)
Meaning
-60dB default
-54dB
-48dB
-42dB
-38dB
-66dB
E. Auto Pause Mode Setting
This menu allows to select whether the AUTO PAUSE PLAY mode is turned on or off. (Refer to page 37)
Note : If the power is once turned off and on again, this mode will become Off condition.
Meaning
The AUTO PAUSE PLAY mode is turned off. default
The AUTO PAUSE PLAY mode is turned on.
F. Balanced Output Level Setting
This menu selects the standard level of Balanced Output. (Refer to page 11)
Meaning
+4dBu default
-10dBV
Display
Display
Display
G. Wireless Remote Control
This menu selects whether the CR300 is controlled by a wireless remote controller or not. (Refer to page 14)
H. Sample Rate Converter Thru
This menu selects whether the 44.1kHz digital signal is input through the SRC(Sample Rate Converter) or
not. (Refer to page 10)
I. Digital Out
This menu selects whether a signal is output from Digital Out terminal. (Refer to page 10)
Meaning
The CR300 can be controlled by a wireless remote controller. default
The CR300 cannot be controlled by a wireless remote controller.
Meaning
The input signal passes through the SRC. default
The input signal goes around the SRC.
Meaning
A signal is output from Digital Out terminal. default
A signal is not output from Digital Out terminal.
Display
Note : If the power is once turned off and on again, this mode will become Off condition.
Display
Display
As shown in the drawing below, when the AUTO PAUSE mode is on,
the letter “P” is displayed.