Fostex CR300 - Manual (Page 33)

33
CR300 <PRB1291-A>
Load a CD-RW disc which has
been finalized.
B. TOC erasing
(Possible on a finalized CD-RW)
Label side
1
2
Press the ERASE button.
3
Press the pause ( ) button to start
the TOC erasing.
• The recorder stops when TOC erasing is completed.
• You can stop the erase process by
pressing the Stop ( ) button for 10
s e c o n d s . H o w e v e r , i f t h e e r a s e
operation is stopped, the message
"CHECK", "DISC" appears to indicate
that the disc has not been normally
erased. • The function indicator lights in orange and
TOC Erasing starts.
• During TOC erasing, "ERS * : ** " while the
remaining time is displayed.
3 2 1
Function indicator
REPEAT
FADER TRACK NO.
WREITE
REC
Do not allow more than 8 seconds to elapse after step 2 has been performed before
proceeding with step 3.
• For a disc loading, refer to page 15.
• The display panel successively displays "TOC" and
"ERASE?" . Then the function indicator blinks in orange
indicating that the recorder is in TOC erase standby mode.
• the FINALIZE indicator lights.
Switching erase modes
Each press of the ERASE button
switches erase modes in the order
shown below.
Erase Off ➔ A. Last track erasing
Finalized CD-RW discs:
Load a CD-RW disc
w h i c h h a s b e e n
recorded on.
For a disc loading, refer to page 15.
A. Last track erasing
(take a few seconds. Not possible on a finalized CD-RW)
1
2
Press the ERASE
button.
• The display panel successively displays "LAST", "TRACK" and "ERASE?" . Then the
function indicator blinks in orange indicating that the recorder is in last track erase standby
mode. The display panel displays the number of the track that can be erased and "TRACK"
and "ERASE."
3
• The function indicator lights in orange and last track erasing starts.
• During last track erasing, the number of the erasing track and "TRACK"
and "ERASE" blinks successively.
Press the pause ( )
button to start the
last track erasing.
• The recorder stops when Last track erasing stops.
C. All tracks erasing
Do not allow more than 8 seconds to elapse after step 2 has been performed before
proceeding with step 3.
Erase Off ➔ B. TOC erasing
C. All tracks erasing
Label side