Fostex FD-4 - Manual (Page 18)

18
Names and Functions
4 3 2 1
1 2
1 2 3 4 5 6
7 8 9 10
11
12 13 14 15
INPUT 3
R MON OUT L R ST OUT L AUX RTN 1
R MONO/L
AUX RTN 2
R MONO/L 2 AUX SEND 1 4 INSERT 3
INPUT 4
SCSI OUT IN
DATA
R
RECORDER IN
L IN
MIDI
OUT PUNCH
IN/OUT
DATA MIDI
POWER
1.Input jacks [1, 2, 3, 4] (Connector: phone)
Connect sound sources, such as musical instruments and
microphones, here.
Connect a microphone to input jacks 3 and 4, which are
equipped with TRIM switches that allow you to switch
according to the connected microphone output level. Input
channels 3 and 4 also support balanced XLR connectors on
the rear panel.
Front Panel (Input/Output Section)
The phone jacks for input channels 3 and 4 on the front
panel have priority. If you connect sound sources to these
jacks, the balanced XLR jacks for input channels 3 and 4 on
the rear panel will be disabled.
2.Headphone jack [PHONES] (Connector: stereo TRS phone)
Connect headphones here. You can adjust the headphone
volume using the MASTER knob in the monitor section.
1. Monitor Out jacks [MON OUT L, R] (Connector: RCA pin)
Connect monitoring speakers and amplifier or powered
speakers here. These jacks output signals selected by the
SELECTOR in the monitor section (L/R, L/R+MON, or MON).
Use the MASTER knob in the monitor section to adjust the
output level.
Rear Panel (Input/Output Section)
2. Stereo Out jacks [ST. OUT L, R] (Connector: RCA pin)
These jacks output stereo bus L/R signals. Connect these
jacks to the input jacks of a master recorder. You can adjust
the output level using the master fader L/R.
4 3 2 1
R MON OUT L
R ST OUT L