Fostex FD-4 - Manual (Page 37)

37
Handling Programs
PGM 01 New PGM
2
3 1 UNDO/
PUNCH AUTO
PITCH VARI
R L
SHIFT
4/R 3/L 2/R
SEL DISP SEL
DIGITAL MULTITRACKER
1/L
CLIPBOARD PLAY LOCATE ABS 0 LOCATE REC END F FWD REWIND PLAY STOP RECORD
REDO EDIT
START IN OUT
AUTO PLAY
EXECUTE /YES EXIT /NO HOLD/ STORE
END IN OUT
PGM SEL
AUTO RTN
SETUP TIME BASE
ACCESS
CLIPBOARD AUTO PUNCH AUTO RTN
ADD. TRACK
PREVIEW
RECORD TRACK
P. EDIT SHUTTLE JOG
ELECT
LOC MEM
LOCATE
DRIVE
AUTO A.PUNCH
SYNC OUT
CLK SCSI
DRIVE
AUTO A.PUNCH
SYNC OUT
CLK SCSI
? SURE
7. When you finish entering the title, press the EXECUTE/YES
key.
Program 2 (PGM 02) and its title are set.
The display shows the ABS Time Base indication of the
Program.
<Important!>
• When you create a new Program by selecting the [New PGM
?] menu, a new Program is created with an increment
number.
That is, if only one Program exists and when you create a
new Program, it will be named Program 2.
If Programs 1–5 already exist, a new Program number will be
6.
• If there is insufficient recording space on the disk, you cannot
create the new Program. Each time you create a new
Program, the recordable area on the disk will decrease.
If multiple Programs exist on the disk, you need to select a
Program to record, play, or edit. This section describes
how to select a Program.
Using the Program Change function
<Note>
You cannot use the Program Change function when the FD-4 is in SETUP
mode.
1. When the FD-4 is stopped, press the STORE key while
holding down the HOLD/> key. (Or press the HOLD/> key
while holding down the STORE key.)
2. Turn the JOG dial to select the desired Program number
(flashing).
Rotating the JOG dial counter-clockwise decreases the
number, and rotating it clockwise increases the number.
If you turn the JOG dial clockwise all the way, [New PGM
?] will be selected.
Select [New PGM ?] to create a new Program as mentioned
in the previous section “Creating a new Program.”
For example, you can select one of seven Programs as
follows:
You can select up to PGM
01 in this direction.
You can select from PGM 03 up to New
PGM in this direction.
3. Press the EXECUTE/YES key.
The ABS Time Base indication for the selected Program
appears.
In this way, you can be sure to select a Program before
you start working.
PGM 02 PGM 03 PGM 04 PGM 05 PGM 06 PGM 07