Fostex FD-4 - Manual (Page 67)

Locate Function
67
1
2
3
Locate
Playback
AUTO RTN START point
AUTO RTN END point
Stop
<Auto Return operation>
RTN
AUTO
EQ EQ
3. Press the LOCATE key.
The FD-4 locates the point and plays as shown in the
diagram.
• You can set a preroll time in the [Preroll ?] menu in SETUP mode
so that the FD-4 will start playback preroll time before the locate
point. You can set the preroll time from 0 to 10 seconds. Refer to
the chapter “Changing the Initial Settings (SETUP Mode)” on page
85.
Auto Return
This function allows the FD-4 to play data up to the AUTO
RTN END point, then automatically locate the AUTO RTN
START point as shown in the diagram below.
To enable this function, AUTO RTN mode should be on and
the AUTO RTN START point and AUTO RTN END point
should already be set.
Executing the Auto Return function
1. Store the AUTO RTN START and AUTO RTN END points.
Refer to the chapter “Storing a Locate Point (Edit Point)”
on page 63 for information on storing the desired points
in the AUTO RTN START key and the AUTO RTN END
key.
2. Press the AUTO RTN/AUTO PLAY key to turn on the [RTN]
indicator at the bottom of the display.
3. Start playback a little before the AUTO RTN END point.
The FD-4 operates as shown in the diagram and stops at
the AUTO RTN START point.
• You can set a preroll time in the [Preroll ?] menu in SETUP mode
so that the FD-4 will start playback preroll time before the locate
point. You can set the preroll time from 0 to 10 seconds. Refer to
the chapter “Changing the Initial Settings (SETUP Mode)” on page
85.