Fostex FD-4 - Manual (Page 39)

39
Handling Programs
44.1kHz
SETUP
DRIVE
AUTO A.PUNCH
SYNC OUT
CLK SCSI
44.1kHz
SETUP
DRIVE
AUTO A.PUNCH
SYNC OUT
CLK SCSI
PGM
44.1kHz
SETUP
DRIVE
AUTO A.PUNCH
SYNC OUT
CLK SCSI
1
1, 4
3, 5
4
4
UNDO/
PUNCH AUTO
PITCH VARI
R L
SHIFT
4/R 3/L 2/R
SEL DISP SEL
DIGITAL MULTITRACKER
1/L
CLIPBOARD PLAY LOCATE ABS 0 LOCATE REC END
F FWD REWIND PLAY STOP RECORD
REDO EDIT
START IN OUT
AUTO PLAY
EXECUTE /YES EXIT /NO HOLD/ STORE
END IN OUT
PGM SEL
AUTO RTN
SETUP TIME BASE
ACCESS
CLIPBOARD AUTO PUNCH
AUTO RTN
ADD. TRACK
PREVIEW
RECORD TRACK
P. EDIT SHUTTLE JOG
ELECT
LOC MEM
LOCATE
Editing a Program title
You can name the Program as explained in the “Creating a
new Program” section. You can also change the title later
by using the [Title Edit ?] menu in SETUP mode.
<Note>
You can edit the title of the selected Program before you select
SETUP mode. You cannot select a Program after the FD-4
enters SETUP mode. Be sure to select the desired Program
using the steps explained in the “Using the Program Change
function” section.
1. Press the SETUP key while the FD-4 is stopped.
The FD-4 enters SETUP mode and displays the first
hierarchy level of the SETUP menu that was selected
before you turned off the power.
2. Turn the JOG dial to select the first hierarchy level of the
[Title Edit ?] (title edit) menu.
The currently-selected Program number also appears.
You can also use the HOLD/> key, the REWIND button, or
the F FWD button to select the first hierarchy level
display.
3. Press the EXECUTE/YES key.
The currently-selected Program title appears with the left-
most character flashing.
4. Press the HOLD/> key, the REWIND button, or the F FWD
button to move the flashing cursor, and use the JOG dial to
enter characters or numbers.
To move the flashing cursor, press the HOLD/> key, the
REWIND button, or the F FWD button. The F FWD button
is the most convenient.
You can enter up to 16 characters, nine of which will
appear on the display.
You may enter the following characters and numbers:
5. After you enter the title, press the EXECUTE/YES key.
The new title is confirmed, and the ABS time value of the
Program appears.