Fostex FD-4 - Manual (Page 48)

48
Special Application (Punch In/Out Recording)
4. Press the STOP button.
5. Play track 3 and check the result of Punch In/Out.
<Caution after Punch Out>
At “Take” of punch out, the punch-in recording track will not immedi-
ately enter the repro monitor mode from the input monitor mode
enter the repro monitor mode about two seconds after mute play-
back. This is a functional feature of FD-4 and not a malfunction.
<Hint>
You can use the PLAY button and the RECORD button, instead of
using the foot switch. Follow the steps below.
This method also does not allow you to record another take un-
less you stop the FD-4 first.
Procedure:
1
.Press the PLAY button to start playback from a point slightly
before the Punch In point.
2
.Press the RECORD button while holding down the PLAY
button at the desired Punch In point. (Punch In recording starts.)
3
.Press the PLAY button at the desired Punch Out point.
(Recording is punched out.)
• If you press only the RECORD button in both steps 2 and 3,
you can rehearse Punch In/Out.
Undo/Redo Manual Punch In/Out recording
You can undo or redo Manual Punch In/Out recording.
Press the UNDO/REDO key after recording is complete to
restore the conditions that existed prior to the recording.
Press the UNDO/REDO key again to restore the conditions
that existed after the recording. Follow the notes below:
<Note-1>
The Undo/Redo function is effective only when the FD-4 is stopped.
<Note-2>
The Undo/Redo is ineffective if you perform one of the following
operations after you finish recording.
• When a new recording is made.
• While a new editing is executed (such as Copy & Paste, Move
& Paste, or Erase).
• When in the AUTO PUNCH ON mode, when the AUTO PUNCH
IN point is passed in the PLAY (or RECORD) mode.
• When the power is momentarily switched off.
• When the program is changed.
• When the disk is ejected.