FUJITSU MAT3147NC/NP - Manual (Page 62)

4-12 C141-E201
(2) SCSI connector and power supply connector
The connector for the SCSI bus is an unshielded SCA-2 connector conforming to SCSI-3 type
which has two 40-pin rows spaced 1.27 mm (0.05 inch) apart. The power connector is included in
the SCSI connector.
Figure 4.14 shows the SCSI connector. See Section B.1 in Appendix B for signal assignments on
the connector.
For details on the physical/electrical requirements of the interface signals, refer to Sections 1.3 and
1.4 in SCSI Physical Interface Specifications.
Figure 4.14 SCA2 type 16-bit SCSI connector
(3)
Connector for external operator panel
This connector is not available for NC model drives.