FUJITSU MPB3052AT - Manual (Page 14)

C141-E045-02EN xiii
TABLES
page
1.1 Specifications ................................................................................................................. 1 - 4
1.2 Model names and product numbers................................................................................ 1 - 5
1.3 Current and power dissipation ........................................................................................ 1 - 6
1.4 Environmental specifications.......................................................................................... 1 - 8
1.5 Acoustic noise specification ........................................................................................... 1 - 8
1.6 Shock and vibration specification................................................................................... 1 - 9
3.1 Surface temperature measurement points and standard values ....................................... 3 - 5
3.2 Cable connector specifications ....................................................................................... 3 - 8
4.1 Self-calibration execution timechart ............................................................................... 4 - 9
4.2 Write precompensation algorithm .................................................................................. 4 - 10
4.3 Write clock frequency and transfer rate of each zone ..................................................... 4 - 15
5.1 Signal assignment on the interface connector................................................................. 5 - 3
5.2 I/O registers .................................................................................................................... 5 - 7
5.3 Command code and parameters...................................................................................... 5 - 14
5.4 Information to be read by IDENTIFY DEVICE command ............................................ 5 - 30
5.5 Features register values and settable modes ................................................................... 5 - 34
5.6 Diagnostic code .............................................................................................................. 5 - 37
5.7 Features register values (subcommands) and functions.................................................. 5 - 48
5.8 Format of device attribute value data.............................................................................. 5 - 50
5.9 Format of insurance failure threshold value data ............................................................ 5 - 51
5.10 Command code and parameters...................................................................................... 5 - 55
5.11 Recommended series termination for Ultra DMA .......................................................... 5 - 73
5.12 Ultra DMA data burst timing requirements .................................................................... 5 - 79
6.1 Default parameters.......................................................................................................... 6 - 6