Furuno SC-60 - Manual (Page 24)

2. INSTALLATION
2-10
2.3.2 Bulkhead mount
For mounting on a bulkhead, use the bulkhead mounting plate supplied with the
installation materials.
1. Unfasten four screws from the top cover to open the front panel.
2. Unfasten two screws to dismount the angular rate sensor.
BEA
CON
Angular Rate Sensor
20P8171
Processor unit, top view
3. Fasten the bulkhead mounting plate to the angular rate sensor. Align the
center graduation on the sensor with the hole of the bulkhead mounting plate
and tighten fixing screws.
Scale
Hole of bulkhead
mounting plate
Angular Rate Sensor
Mounting Base
Fixing Screw
Center Mark
Angular rate sensor, top view