Furuno SC-60 - Manual (Page 56)

3. OPERATION
3-18
3.11 OTHERS Menu
The OTHERS menu chooses whether to output last-used heading data, and
smooths rate of turn meter reading (rate-of-turn meter required).
1. Press the [MENU] key to display the main menu.
MAIN MENU
SATELLITE
DGPS
I/O SETUP
INST MENU
ERASE
TRIP MENU ALARMS
MESSAGES
GPS SETUP
SYS SETUP
SOFT VER.
OTHERS
Main menu
3. Choose OTHERS and press the [ENT] key.
OTHERS
HOLD HDG DATA: OFF
SMOOTH ROT : 2.5SEC
ROT RANGE :
60 °/min
Others menu
4. Choose HOLD HDG DATA and press the [ENT] key.
5. Choose ON to use, at power on, last-used heading until current heading is
calculated. Last-used heading flashes to inform that it is unreliable.
6. Press the [ENT] key.
7. Choose SMOOTH ROT and press the [ENT] key.
8. Use the Omnipad to enter smoothing time. Choose location with ◄ or ►;
change value with ▲ or ▼.
9. Press the [ENT] key.
10. Choose ROT RANGE and press the [ENT] key.
11. Choose the range of the ROT graph: 30, 60 or 90 and press the [ENT] key.
12. Press the [DISP] key to close the menu.