Furuno SC-60 - Manual (Page 25)

2. INSTALLATION
2-11
4. Loosen four screws on the angular rate sensor mounting base, and then
fasten the bulkhead mounting plate to the angular rate sensor mounting
base.
BEACON
20P8171
0-),
0-),
0-),!
Bulkhead Mounting Plate
Angular Rate Sensor
Angular
Rate
Sensor
Mounting
Base
Top Fixing
Hole (x2)
Processor unit, top view
5. Close the top cover of the processor unit.
6. Partially screw in two tapping screws for the top fixing holes of the processor
unit in the mounting location. Hang the processor unit on the tapping screws,
using the top fixing holes. Screw in two tapping screws for the bottom fixing
holes, and then tighten the top fixing holes.