Freescale Semiconductor 802.15.4 - Manual (Page 10)

1-2 Embedded Bootloader Reference Manual, Rev 0.0 Freescale Semiconductor
1.1.1 Ported Targets
The Embedded Bootloader must be ported (I/O mapped) to a specific PCB for proper functionality and is
currently ported to the following Freescale PCBs:
Axiom AXM-0308:
• PC Communication Interface: RS232/UART on COM1 (SCI1)/
RS232/UART on COM2 (SCI2)
• Safe Mode Boot Short pins 2-3 on COM1 (SCI1)/
COM2 (SCI2)
• Version Number “AX-0308 Ver 5.01”
DIG528-2 EVK
• PC Communication Interface: RS232/UART on COM1 (SCI1)/
USB (SCI2)
• Safe Mode Boot Short pins 2-3 on COM1-port (SCI1)
• Version Number “528&536 Ver 5.01”
DIG536-2 SARD
• PC Communication Interface: RS232/UART on COM1 (SCI1)
• Safe Mode Boot Short pins 2-3 on COM1-port (SCI1)
• Version Number “528&536 Ver 5.01”
RD01
• PC Communication Interface: RS232/UART/USB on COM1 (SCI1)/
RS232/UART/USB on COM2 (SCI2)
• Safe Mode Boot Short pins 2-3 on COM1 (SCI1)/
COM2 (SCI2)
• Version Number “ RD01 Ver 5.01”
NOTE
The generic RD01 target can be used with any PCB using the Freescale
Reference Design version 01 I/O layout. The PCB must support at least
one communication interface. If a USB is the only interface, use a
jumper to short SCI pins 2 and 3 to make Safe Mode Boot available.
Refer to Section 6.3 for details on how to port the Embedded Bootloader to a specific PCB.