Freescale Semiconductor 802.15.4 - Manual (Page 22)

3-6 Embedded Bootloader Reference Manual, Rev 0.0 Freescale Semiconductor
3.1.4 Using the Help Menu
Click on the Embedded Bootloader About box to see the Embedded Bootloader sub version number.
Figure 7 Embedded Bootloader Tool Version
NOTE
The last line is reported from the Embedded Bootloader on the PCB.
This version number is only sent to the PC from power up (not on
reset).
3.1.5 Changing the NVM Data in Flash or File
If users click on an application in the list, it displays the NVM values in the selected application file. If
the uploaded application supports NVM dump, it is possible to read the NVM from the board.
The NVM data can be changed in two different ways:
1. If the uploaded application does not support NVM data editing it is possible to edit the NVM data
in the application file before it is uploaded to the board and save it back in the application file for
later upload.
2. If the uploaded application does support NVM data editing it is possible to edit the NVM data
after the board has been uploaded with the application. For example, the file contains default
values. The Freescale EVK PTC application supports this feature.
NOTE
No production specific information is available in this example window.
Use caution when editing the clock related configuration values. The
values must match each other. There is no sanity check on the user
entered values, though there is a check on length. See the
MC908HCS08GB60/GT60 MCU Data Sheet, MC9S08GB60/D about
how to specify valid register values for the HCS08.