Furuno 851 MARK-2 - Manual (Page 19)

2. WIRING
2-2
FM-C10FPD002-200 000-143-891 20m
FM-C10FPD002-300 000-143-890 30m
*2:The following cables are optionally supplied for heading sensor connection.
Type
Code no. Remarks
FM-C6FPD001-050 000-143-897 PG-1000 (5m)
FM-C6FPD001-100 000-143-898 PG-1000 (10m)
*3:The following cables can be used for NMEA 0183 format connection.
Type
Code no. Remarks
FM-C6FPD002-050 000-143-895 6P-6P(5m), Cross type
FM-C6FPD002-100 000-143-896 6P-6P(10m) , Cross type
Signal cable connection
1. Connect the signal cable to DJ-1 on the rear panel of the display unit.
Rubber cover
DJ Connector
Boot-band
Cable
Display unit DJ-1
Figure 2-2
2. Cover the connector with the rubber cover. The projection on the connector
base is inserted into the groove on the rubber cover.
Display unit
Rubber cover
Grasp Grasp
Groove
Figure 2-3
3. Put the boot-band as shown below, and tighten it.
Display Unit
Boot-band
Figure 2-4