Furuno 851 MARK-2 - Manual (Page 27)

3. ADJUSTMENT
3-4
● INSTALLATION SETUP 2 ●
Select item and option
by trackball.
1. Align Heading
2. Adjust Sweep Timing
3. On Hours 0000019.8 H
4. Tx Hours 0000016.0 H
. . . . . . . . . . . . . . . . .
Press HM-OFF to temporarily
hide menu.
<Press MENU for main menu.>
Figure 3-6 Installation setup 2 menu
3.4 Entering Initial Settings
1. At the Installation Setup 1 menu, press the omnipad to select Key Beep. (Key
Beep turns on or off the buzzer which sounds when a key is pressed.)
2. Press the omnipad to select OFF or ON.
3. Select Hdg Sensor.
4. Select type of heading sensor connected to the radar; MAGnetic compass or
GYROcompass.
5. Press the [ENT] key.
Leave the menu open to complete the next several adjustments.