Furuno 851 MARK-2 - Manual (Page 26)

3. ADJUSTMENT
3-3
3.3 Displaying the Installation Menus
Two sets of installation menus, Installation Setup 1 and Installation Setup 2
enable entry of initial settings and adjustment of the radar.
Procedure
1. Turn on the power while pressing and holding down the [HM OFF] key.
2. Press the [MENU] key.
● MAIN MENU ●
Select item by ▲▼ keys
and press ENT key.
1. Backlight/Brilliance
2. P/L, IR, NR & Radar Mode
3. Nav Data
4. Mode & Function
5. Tuning
AUTO MANUAL
6. Self Check
7. Installation Setup 1
. . . . . . . . . . . . . . . . .
Press HM-OFF to temporarily
hide menu.
<Press MENU key to escape.>
Figure 3-4 main menu
3. Press the omnipad to select Installation Setup 1 and press the [ENT] key.
● INSTALLATION SETUP 1 ●
Select item and option
by
▲▼ keys.
1. Key Beep
2. Hdg Sensor
3. Ant on Tx
4. Demo Display
5. Rotation Speed
. . . . . . . . . . . . . . . . .
6. Installation Setup 2
Press HM-OFF to temporarily
hide menu.
<Press MENU for main menu.>
OFF ON
MAG GYRO
ROTATE STOP
OFF
24 48 rpm
ON
Figure 3-5 Installation setup menu 1
4. To display the Installation Setup 2 menu, press the omnipad to select
Installation Setup 2 and press the [ENT] key.