FUJITSU T5140 - Manual (Page 17)

1
Communicating With the System
This section includes information on low-level communication with the system,
using the Integrated Lights Out Manager (ILOM) tool and the system console.
■ “ILOM Overview” on page 1
■ “Log In to ILOM” on page 2
■ “Log In to the System Console” on page 3
■ “Display the ok Prompt” on page 3
■ “Display the ILOM ->Prompt” on page 4
■ “Use a Local Graphics Monitor” on page 5
ILOM Overview
The ILOM service processor runs independently of the server and regardless of the
system power state as long as AC power is connected to the system. When you
connect your server to AC power, the ILOM service processor immediately starts up,
and begins monitoring the system. All environmental monitoring and control is
handled by ILOM
The -> prompt indicates that you are interacting with the ILOM service processor
directly. This prompt is the first prompt you see when you log in to the system
through the serial management port or network management port, regardless of the
host’s power state.
You can also access the ILOM service processor prompt (->) from the OpenBoot ok
prompt, or from the Solaris # or % prompt, provided the system console is configured
to be accessible through the serial management and network management ports.
The ILOM service processor supports a total of five concurrent sessions per server,
four SSH connections available through the network management port and one
connection available through the serial management port.