FUJITSU T5140 - Manual (Page 61)

Handling Faults 45
2. At the ILOM -> prompt, type:
The system is set to run full POST diagnostics on system reset.
3. To return to your normal diagnostic settings after running POST, type:
Related Information
■ “Discover Faults Using ILOM” on page 44
■ “Locate the System” on page 45
■ “Clear a Fault” on page 49
■ “Bypassing Minor Faults” on page 46
▼ Locate the System
1. To turn on the Locator LED, from the ILOM service processor command prompt,
type:
2. To turn off the Locator LED, from the ILOM service processor command
prompt, type:
3. To display the state of the Locator LED, from the ILOM service processor
command prompt, type:
Note – You do not need administrator permissions to use the set /SYS/LOCATE
and show /SYS/LOCATE commands.
Related Information
■ “Discover Faults Using ILOM” on page 44
■ “Discover Faults Using POST” on page 44
-> set /SYS keyswitch_state=diag
-> set /SYS keyswitch_state=normal
-> set /SYS/LOCATE value=Fast_Blink
-> set /SYS/LOCATE value=off
-> show /SYS/LOCATE