FUJITSU T5140 - Manual (Page 46)

30 SPARC Enterprise T5140 and T5240 Servers Administration Guide • July 2009
5. To check the status of a RAID rebuild, type the following command:
For example:
This example indicates that RAID volume c1t1d0 is resynchronizing.
If you type the command again once synchronization has completed, it indicates
that the RAID mirror is finished resynchronizing and is back online:
For more information, see the raidctl(1M) man page.
Related Information
■ “Disk Slot Numbers” on page 35
■ “Hot-Plug a Nonmirrored Disk” on page 30
▼ Hot-Plug a Nonmirrored Disk
1. Verify which hard drive corresponds with which logical device name and
physical device name.
See “Disk Slot Numbers” on page 35 .
Ensure that no applications or processes are accessing the hard drive.
# raidctl
# raidctl -l c1t0d0
Volume Size Stripe Status Cache RAID
Sub Size Level
Disk
----------------------------------------------------------------
c1t0d0 136.6G N/A SYNC OFF RAID1
0.0.0 136.6G GOOD
0.1.0 136.6G GOOD
# raidctl -l c1t0d0
Volume Size Stripe Status Cache RAID
Sub Size Level
Disk
----------------------------------------------------------------
c1t0d0 136.6G N/A OPTIMAL OFF RAID1
0.0.0 136.6G GOOD
0.1.0 136.6G GOOD