FUJITSU T5140 - Manual (Page 26)

10 SPARC Enterprise T5140 and T5240 Servers Administration Guide • July 2009
5. Type the load command with the path to the new flash image.
The load command updates the service processor flash image and the host
firmware. The load command requires the following information:
■ IP address of a TFTP server on the network that can access the flash image
■ Full path name to the flash image that the IP address can access
The command usage is as follows:
load [-script] -source tftp:// xxx.xxx.xx.xx/pathname
where:
■ -script - Does not prompt for confirmation and acts as if yes was specified
■ -source - Specifies the IP address and full path name (URL) to the flash
image
After the flash image has been updated, the system automatically resets, runs
diagnostics, and returns to the login prompt on the serial console.
-> load -source tftp://129.168.10.101/ pathname
NOTE: A firmware upgrade will cause the server and ILOM to be reset.
It is recommended that a clean shutdown of the server be done prior
to the upgrade procedure.
An upgrade takes about 6 minutes to complete. ILOM will enter a
special mode to load new firmware.
No other tasks can be performed in ILOM until the firmware upgrade
is complete and ILOM is reset.
Are you sure you want to load the specified file (y/n)?y
Do you want to preserve the configuration (y/n)? y
.................................................................
Firmware update is complete.
ILOM will now be restarted with the new firmware.
Update Complete. Reset device to use new image.
->
U-Boot 1.1.1 (May 23 2008 - 21:30:12)
***
POST cpu PASSED
POST ethernet PASSED
Hit any key to stop autoboot: 0
## Booting image at fe080000 ***
IP Protocols: ICMP, UDP, TCP, IGMP
Checking all file systems...
fsck 1.37 (21-Mar-2005)
Setting kernel variable ...
... done.
Mounting local filesystems...