Frymaster FOOTPRINT 8195915 - Manual (Page 20)

4-6
2. Install the Power Shower by removing
the basket support rack from the frypot.
Raise the element assembly to the up
position and snap the power shower
attachment into position
NOTE: Verify that the Power Shower
O-ring and gasket are present and in
good condition and that the clean-out
screws are installed at each corner.
Snap the Power Shower into position.
DANGER
DO NOT operate the filter without the Power Shower in place. Hot oil will spray out of
the fryer and cause injury.
3. After the cooking oil/shortening has
drained from the frypot, turn the filter
handle to the ON position to start the
pump and begin the filtering process.
There may be a slight delay before the
pump activates.
4. The filter pump draws the cooking oil/shortening through the filter medium and circulates it back
up to and through the frypot during a 5-minute process called polishing. Polishing cleans the oil
by trapping solid particles in the filter medium.
5. After the oil is filtered (about 5 minutes), close the drain valve and allow the fryer to refill. Let
the filter pump run 10 to 12 seconds after the oil/shortening begins to sputter from the Power
Shower openings. Turn the filter off, remove the Power Shower and let it drain.
Turn filter handle to
the ON position