Friedrich 2008 - Manual (Page 9)

7
ELECTRICAL SHOCK HAZARD
WARNING
Plug into a grounded 3 prong outlet.
Do not remove powercord ground prong.
Do not use a plug adapter.
Do not use an extension cord.
Failure to follow these instructions can
result in death, fire, or electrical shock.
This air conditioner must be grounded. This air conditioner
is equipped with a power supply cord having a grounded 3
prong plug. To minimize possible shock hazard, the cord
must be plugged into a mating, grounded 3 prong outlet,
grounded in accordance with all local codes and ordinances.
If a mating outlet is not available, it is the customer’s
responsibility to have a properly grounded 3 prong outlet
installed by a qualified electrical component installer.
It is the customer’s responsibility:
To contact a qualified electrical installer, and to assure
that the electrical installation is adequate and in
conformance with National Electrical Code, ANSI/NFPA
70 - latest edition, and all local codes and ordinances.
Copies of the standards listed may be obtained from:
National Fire Protection Association
One Batterymarch Park
Quincy, MA 02269
Recommended grounding method
To test your power supply cord:
1. Plug power supply cord into a grounded 3 prong outlet.
2. Press RESET.
3. Press TEST (listen for click; Reset button will trip and
pop out).
4. Press and release RESET (listen for click; Reset butto
will latch and remain in). The power supply cord is ready
for operation.
NOTES:
The Reset button must be pushed in for proper
operation.
The power supply cord must be replaced if it fails to trip
when the test button is pressed or if it fails to reset.
Do not use the power supply cord as an off/on switch.
The power supply cord is designed as a protective
device.
A damaged power supply cord must be replaced with
a new power supply cord obtained from the product
manufacturer and must not be repaired.
The power supply cord contains no user serviceable
parts. Opening the tamper-resistant case voids all
warranty and performance claims.
Power Supply Cord
NOTE: Your unit’s device may differ from the ones shown.
A. Reset button
B. Test button
This room air conditioner is equipped with a power supply
cord required by UL. This power supply cord contains
state-of-the-art electronics that sense leakage current. If
the cord is crushed, the electronics detect leakage current
and power will be disconnected in a fraction of a second.
TE
ST
TE
ST
RE
SE
T
RE
SE
T
A
A B
B