FUJITSU IMAGE SCANNER M3092DC User Manual
Page 32
2-8
M3092DC Image Scanner Operation Guide
2.3.5 Installing Driver and Software
The driver and other software are stored on the setup CD-ROM supplied
with the image scanner. Install the driver first, and then install the
software.
•
To install the driver, run “Setup.exe” in the \Driver\Disk1 folder on
the CD-ROM.
The Fujitsu TWAIN32 driver is installed and registered on the
TWAIN32 source selection screen.
•
To install other software, run “Setup.exe” in the \Tools\Disk1 folder
on the CD-ROM.
The following software is installed in “Start” – “Programs” – “Tools”:
COPY:
Sets the image quality when image data is being
copied by the image scanner.
COPY Help:
Displays Help information concerning COPY.
Image:
Sets the image quality when image data is scanned
by the image scanner.
Image Help:
Displays Help information about Image.
Uninstall Tools: Uninstalls the Tools software.
Launch Help:
Displays Help information about the status-
monitoring program of the scanner operator panel.
Readme:
Displays the Readme.txt.
“Launch” is registered in “Start” – “Programs” – “Startup”. As
“Launch” is required to use the scanner operator panel, do not remove
it.
u Key point
Thoroughly read “Readme.txt” on the CD-ROM before installation.
You must install the driver and all software components in order to
use the operator panel of the image scanner.