FUJITSU T1000 - Manual (Page 32)

6 SPARC Enterprise T1000 Server Installation Guide • April 2007
The slide rail assembly has the following features:
■ The front and rear sections form the slide rail. The front and rear sections expand
to fit rack depths from 24 in. (610 mm) to 29.0 in. (740 mm).
■ Extension brackets are included in the mounting rail kit. The extension brackets
add 2.9 in. (73 mm) to the length of each slide rail.
■ The mounting bracket slides 13 in. (330 mm) out of the slide rail, then locks in
place. If you unlock the mounting bracket, it slides an additional 4 in. (100 mm)
before separating from the slide rail. The mounting brackets mount directly to the
sides of the server chassis.
■ There are two locks on each server mounting bracket ( FIGURE 1-3 ). The lock
enables the mounting bracket to slide forward. The mounting bracket release
allows you to remove the mounting bracket from the slide rail. You also use the
release when pushing the mounting bracket into the slide rail.
FIGURE 1-3 Mounting Bracket Locks
Mounting bracket release
Mounting bracket lock (2 buttons)