Data port and cabling notes, Port locations, Cabling notes – FUJITSU T1000 User Manual
Page 34: Figure 1-5
8
SPARC Enterprise T1000 Server Installation Guide • April 2007
Data Port and Cabling Notes
Port Locations
shows the ports on the server.
FIGURE 1-5
Locations of Ports and Connectors on the Rear Panel
Cabling Notes
The following list describes the server’s cable connections and ports:
■
Minimum cable connections for the server:
■
At least one system on-board Ethernet network connection (NET port)
■
System controller serial management port (SERIAL MGT port)
■
System controller network management port (NET MGT port)
■
Power cable
■
System controller (SC) management ports.
There are two SC management ports
for use with the ALOM CMT system controller.
■
The SC serial management port (labeled SERIAL MGT) uses an RJ-45 cable and
is always available. This is the default connection to the ALOM CMT system
controller.
■
The SC network management port (labeled NET MGT) is the optional
connection to the ALOM CMT system controller. See
Controller Network Management Port” on page 31
. The SC network
management port uses an RJ-45 cable for a 10/100BASE-T connection. This
port does not support connections to Gigabit networks.
See the SPARC Enterprise T1000 Server Overview for more information.
SC network management port
SC serial management port
NET3
NET2
NET1
NET0
Serial port
AC in