FUJITSU T1000 - Manual (Page 52)

26 SPARC Enterprise T1000 Server Installation Guide • April 2007
Note – To see these status and error messages, connect a terminal or terminal
emulator to the serial management port (SERIAL MGT). For a basic procedure to
connect a terminal or terminal emulator, see
“To Power On the System for the First
Time” on page 27 .
For a more detailed discussion on configuring the system console and connecting
terminals, refer to the SPARC Enterprise T1000 Server Administration Guide.
ALOM CMT System Controller
After the system console finishes its low-level system diagnostics, the ALOM CMT
system controller initializes and runs a higher level of diagnostics. When you access
the ALOM CMT system controller using a device connected to the serial
management port, you see the output of the ALOM CMT diagnostics.
By default, the network management port is configured to automatically retrieve
network configuration using Dynamic Host Configuration Protocol (DHCP) and to
allow connections using Secure Shell (SSH).
Note – If you are unable to use DHCP and SSH on your network, you must connect
to the ALOM CMT system controller using the serial management port to
reconfigure the network management port. See
“To Configure the System Controller
Network Management Port” on page 31 .
Once the network management port (NET MGT) has been assigned an IP address,
you can connect to the ALOM CMT system controller using Telnet or SSH.
Passwords
There is no default password when connecting to the ALOM CMT system controller
for the first time using the serial management port. To set the admin password, see
“To Log In To the System Controller Using the Serial Management Port” on page 29 .
When connecting to the ALOM CMT system controller using the network
management port for the first time, the default password is the last eight digits of
the chassis serial number. The serial number is located on the rear of the server. It is
also printed on the system information sheet that shipped with the server.