FUJITSU T1000 - Manual (Page 49)

Chapter 2 Installing the Server 23
▼ To Connect the Ethernet Network Cables
The server has four network connectors, marked NET0, NET1, NET2, and NET3
(
FIGURE 2-9 ). These connectors are RJ-45 Gigabit Ethernet.
1. Connect a Category 5 cable from your network switch or hub to Ethernet Port 0
( NET0) on the rear of the chassis.
NET0 is the farthest left port in the 4-port network cluster in FIGURE 2-9 .
2. Connect Category 5 cables from your network switch or hub to the remaining
Ethernet ports ( NET1, NET2, NET3), as needed.
TTYA Serial Port
The TTYA serial port has a DB-9 connector. A DB-9 to RJ-45 adapter cable is
included in the shipping kit.
Note – This serial port is not the same as the SC serial management port. Use the
serial port only for general-purpose serial data transfers.
FIGURE 2-11 Serial Port (TTYA)
▼ To Connect the AC Power Cable to the Server
Powering on the system for the first time requires special preparation and
procedures. For example, if you have not prepared a display before connecting the
AC power cable, system messages might be lost.
1. Finish the hardware procedures in this chapter, but do not attach the AC power
cable yet.
Powering on the system for the first time requires special preparation and
procedures. For example, if you have not prepared a display before connecting the
AC power cable, system messages may be lost. You will be instructed to connect the
server to AC power in
“Powering On the Server for the First Time” on page 25 .
1 5
6 9