To reset the system controller, To reset – FUJITSU T1000 User Manual
Page 60
34
SPARC Enterprise T1000 Server Installation Guide • April 2007
Note –
After setting the configuration parameters, you must reset the system
controller for the new values to take affect. See
“To Reset the System Controller” on
▼
To Reset the System Controller
●
Issue the resetsc command.
You are prompted to confirm that you want to reset the system controller. Type y
when prompted.
Note –
To bypass the confirmation message, specify the –y flag to the resetsc
command.
The system controller resets, runs diagnostics, and returns to the login prompt.
diag_verbosity normal
diag_level max
diag_mode normal
sys_autorunonerror false
ser_baudrate 9600
ser_parity none
ser_stopbits 1
ser_data 8
netsc_enetaddr
xx:xx:xx:xx:xx:xx
sys_enetaddr
yy:yy:yy:yy:yy:yy
sc> resetsc
Are you sure you want to reset the SC [y/n]? y
User Requested SC Shutdown
ALOM POST 1.x
Dual Port Memory Test, PASSED.
TTY External - Internal Loopback Test
TTY External - Internal Loopback Test, PASSED.
TTYC - Internal Loopback Test