Step 3.5 securing the dishdrawer – Fisher & Paykel DD602I User Manual
Page 12
Page DD_11
3.5.1
Partially lift the top mounting tabs by
inserting a flat screwdriver into the Vee
shaped slot. Complete the folding
process by bending about the rows of
oval slots so that the tab is approximately
level and parallel with the underside of
the bench.
3.5.2
Lift the DishDrawer and insert the front
feet into the Slide Runners. While the
machine is still outside the cavity, fold
out the tabs on top of the DishDrawer.
Push the DishDrawer back until the back
feet slide into the rear grooves of the
Retainer. Ensure the DishDrawer is as far
back as it will go.
3.5.3
Insert the Clip Pegs into the Slide
Runners in front of the front feet. Push
the Clip Peg back until it locates in the
two holes on either side of the Slide
Runner. This locks the DishDrawer in
place as well as providing the mounting
clips for the Lower Toe Kick.
3.5.4
Screw in tabs to underside of bench.
Use the two Phillips No. 8 x
5
/
8
screws
supplied to secure the DishDrawer to the
bench. This provides optimal product
rigidity within the cavity.
STEP 3.5 SECURING THE DISHDRAWER