Fisher & Paykel DD602I - Manual (Page 21)

WARNING
CAUTION
Take care not to damage
front surface of panel.
Ensure all cuts are
straight and care is taken
to avoid damage to the
Drawer Front.
Care should be taken in
the following steps.
Overtightening will
damage the Drawer
Front.
CAUTION
I
N
T
E
G
R
A
T
E
D
P
R
O
D
U
C
T
O
N
L
Y
STEP 6.4 FITTING THE BADGE, HANDLE & MOUNTING
PANEL TO THE DRAWER FRONT
6.4.1
Remove Drawer Front Mounting Panel by
withdrawing pins from sides of drawers.
6.4.2
Slide Mounting Panel off in a downwards
and outwards motion.
6.4.3
Using an Allen Key, screw in Mounting
Bracket Nuts. Remove Burrs. Screw in
flush with back surface.
6.4.4
Fit the Drawer Mounting Panels using the
screws supplied.
6.4.5
Feed wires through to the back and press
badge into hole, if needed adhere badge
to Drawer Front with a glue or silicon
sealant.
6.4.6
Fit the customer supplied handle.
Page DD_20