Fisher & Paykel DD602I - Manual (Page 14)

Page DD_13
Ensure the Toe Kick Pins
are positioned on a
wooden chopping board
to avoid damage to
surrounding area.
IMPORTANT
STEP 4.3 TRIMMING THE TOE KICK PINS
Before cutting the Lower
Toe Kick, ensure the Toe
Kick is positioned on a
wooden chopping board
to avoid damage to
surrounding area.
IMPORTANT
4.2.2
To establish which groove to trim along,
measure the Toe Kick against both sides
of the product, allowing a minimum gap
of 3 /
32
” (2.5mm) between the Upper and
Lower Toe Kicks.
Neatly cut through the vertical ribs of the
Toe Kick and trim along the full length of
the groove.
4.2.3
Bend the cut edges apart slightly and
carefully cut through from the front.
4.2.4
Sand the edges to remove any rough
patches.
4.3.1
Mark the Toe Kick Pins against the
trimmed Lower Toe Kick.
NOTE: DO NOT insert the Pins into the
Kick before cutting to length.
4.3.2
Place the Toe Kick Pin onto a wooden
chopping board and trim the Pin by
cutting down the corresponding groove to
the trimmed Lower Toe Kick. Cut the
outer edges of the Toe Kick Pins from the
inside to the outside.