Fisher & Paykel DD602I - Manual (Page 19)

5.1.4
Drawer Front Mounting Bracket Nut Holes
Using a 11 /
32
” (8.5mm) diameter drill bit, drill out the four screw holes in each door
panel to a depth of 9 /
16
” (14mm). Remove burrs.
At least 5 /
8
” (16mm) of Drawer Front material is required for the Drawer Mounting Nuts
(M6 screw in nut - Type E).
Use of a depth gauge is
recommended when
drilling out holes for
Drawer Front Mounting
Panel.
WARNING
CAUTION
Ensure the drill does not
damage the face of the
Drawer Front.
5.1.5
Toe Kick Mounting Pilot Holes
Using a 3 /
32
” (2.5mm) diameter drill bit, drill out the six screw holes in the Upper
Toe Kick to a depth of 1 /
4
”(6mm).
Lower Toe Kick Mounting Pilot Holes are drilled at the time of installation.
I
N
T
E
G
R
A
T
E
D
P
R
O
D
U
C
T
O
N
L
Y
Page DD_18
* These dimensions are important to ensure the 1 /
4
” (6mm) airflow gap is correctly located.