Follett T400A/W - Manual (Page 11)

11
Step 2 – Installing Satellite-fill icemaker on slide-out track
A. When icemaker is shipped with slide-out track accessory (follow either A or B)
1. Connect inlet water, drain, and power supply to back of vertical utility panel.
2. Place icemaker on slide-out track assembly.
3. Connect drain and water lines.
4. Connect electrical plugs from icemaker to utility panel.
B. When icemaker is installed in and shipped with counter
1. Remove two outer rear screws from icemaker and install supplied spacer and screw (Fig. 3).
2. Place icemaker on slide-out track assembly.
3. Connect drain and water lines.
4. Connect electrical plug from icemaker to utility panel.
5. Remove pin from adjustable leg.
6. Place hold-down strap over leg block and secure strap to slide-out assembly with supplied screws (Fig. 4).
7. Reinstall pin in leg block.
8. At job site remove hold-down strap and make utility connections at rear utility panel.
power cord
bin signal cord
position track accessory so that 2" (51mm) duct
supplied with air-cooled satellite-fill icemaker mates
with back of counter opening.
counter front
grille supplied with air-
cooled satellite-fill icemakes
air in
(air-cooled units only)
bin signal cord
(icemaker connection)
Fig. 3
Fig. 4
Remove screw. Install
supplied screws and spacers.
hold-down strap
(for installation; remove
and discard)
supplied screws (for installation;
remove and discard)