Fargo DTC300 - Manual (Page 106)

RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400/DTC300/DTC300M Card Printer User Guide (Rev. 1.1) 4-49
Resolving the Image Placement problems (continued)
Step Procedure
4 Verify if the Vertical Image Position Setting is set correctly or incorrectly. See
the graphic below.
• If the white border is on the top edge of the card, adjust the Vertical value
by +2.
• If the white border is on the botom edge of the card, adjust the Vertical
value by -2.
a. Click on OK.
b. Run a self-test.
c. If the white border is diminished, continue the adjustment until it is gone.
Graphic B