Resolving the no mag installed error, Resolving the no mag installed error -17 – Fargo DTC300 User Manual
Page 74
Advertising
RESTRICTED USE ONLY
Fargo Electronics, Inc.
DTC400/DTC300/DTC300M Card Printer User Guide (Rev. 1.1)
4-17
Resolving the No Mag Installed Error
All Troubleshooting procedures assume that only factory-authorized supplies are in use in
the Printer.
Step Procedure
1
Review the following information.
•
Symptom: There is not Magnetic Encoder installed.
•
Printer Error State: A print job with Magnetic encoding was sent with no
Magnetic encoder installed in the Printer.
•
LCD Error Display: No Mag Installed
•
Driver Monitor Error Display: No Mag Installed
Continued on the next page
Advertising