Fargo DTC300 - Manual (Page 21)

RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400/DTC300/DTC300M Card Printer User Guide (Rev. 1.1) 2-7
VeriMarkTM - Application Specifications
VeriMarkTM foils will cover a dimensional area of 1.9 cm length x 1.3 cm height. The
exclusive areas are as follows:
• VeriMarkTM Card customers will be able to choose 1 of 8 pre-defined placements
(corners) via Printer Driver (4 positions) Landscape and (4 Positions) Portrait mode.
• VeriMarkTM foil placement will not interfere with card punch slots .
• Foil color base is silver; debossed impression is gold foil.
• VeriMarkTM foil placement will be located 0.4 cm from the edges of the card except for
the top two locations on portrait orientation cards (positions E & F). The foil will be
located 0.9 cm from the top of the card and 0.4 cm from the sides of the card.
HoloMarkTM and Custom HoloMarkTM - Application Specifications
HoloMarkTM and Custom HoloMarkTM foils will cover a dimensional area of 1.5 cm x 1.5
cm. The exclusive areas are as follows:
• HoloMarkTM and Custom HoloMarkTM card end-users will be able to choose 1 of 8
pre-defined placements (corners) via Printer Driver (4 positions) Landscape and (4
positions) Portrait mode.
• HoloMarkTM foil placement will not interfere with card punch slots.
• Foil Color options will be silver or gold.
• Outside edge placement of Foil impression options on card will be 0.4 cm from edge of
card.
• HoloMarkTM foil placement options will be at all four corners of card located 0.4 cm
from edge of card.