Grizzly G7945 - Manual (Page 19)

G7945/G7946 Radial Drill Press
-17-
Table Bracket
Components and Hardware Needed: Qty
Table .................................................................. 1
Crank Handle .................................................... 1
Handle ............................................................... 1
Clamp Bolts (G7945) ......................................... 1
Clamp Bolts (G7946) ......................................... 3
Column .............................................................. 1
Column Support Arm (G7946) .......................... 1
Table Support Arm (G7946) .............................. 1
The table bracket must be installed as described
to properly assemble your drill press. The Model
G7945 comes with a one piece square table and
bracket. The Model G7946 comes with a round
table and two-piece hinged table bracket.
To install the table bracket:
1. Check to make sure the pinion gear is fully
inserted into the hole on the side of the table
bracket shown in
Figure 8.
Figure 7. Column secured to base.
Components and Hardware Needed: Qty
Base ...................................................................1
Column ...............................................................1
Hex Bolts M10-1.5 x 40 (G7946) ........................4
Hex Bolts M8-1.25 x 20 (G7945) ........................4
The column must be secured on the base to
properly assemble your drill press.
To secure the column to the base:
1. Place the column on the base and align the
mounting holes.
2. Secure the column to the base with the four
hex bolts, as shown in Figure 7.
Column and Base
Figure 8. Pinion gear position.
Pinion
Gear
2. Slide the crank handle over the pinion gear
shaft and align the set screw in the crank
handle with the flat portion of the shaft. Secure
with a 3mm hex wrench. See
Figure 9.
3. Thread the handle into the crank handle.
4. Remove the column ring (Figure 10) by
loosening the set screw and remove the rack
(
Figure 9). The end of the rack that has teeth
extending closest to the edge must be posi-
tioned down.
Table
Bracket