Grizzly G7945 - Manual (Page 31)

G7945/G7946 Radial Drill Press
-29-
Head Adjustments
Figure 27. Lock pin location.
The headstock can be tilted from 45° clockwise to
90° counterclockwise.
To tilt the headstock:
1. Loosen the clamp bolt on the right side of the
headstock.
2. Pull out the guide pin located on the left side
of the headstock and rotate the pin 90° as
shown in
Figure 27.
Lock
Pin
3. Tilt the headstock to the desired angle speci-
fied on the scale and tighten the clamp bolt
on the right side of the headstock.
To return to vertical position:
1. Loosen the clamp bolt located on the right
side of the headstock.
2. Move the lock pin back into the guide slot.
3. Return the headstock to the vertical position.
The headstock should lock into place.
Note: The lock pin is only intended to be a
rough indexing tool.
4. For finer adjustments, align the zero mark
on the headstock scale with the line on the
horizontal column.
5. Tighten the clamp bolt.
To adjust the headstock back and forth:
1. Loosen the clamp bolt located on the right
side of the headstock.
2. Turn the black ribbed handle to move the
headstock back and forth the to desired posi-
tion. Tighten the clamp bolt before operating
the machine.