Grizzly G7945 - Manual (Page 20)

-18-
G7945/G7946 Radial Drill Press
Figure 9. Rack orientation (G7946 shown).
Figure 10. Inside bevel in the correct position.
Crank
Handle
Column Ring
Set Screw
5. Insert the rack into the table bracket pocket so
the gear teeth mesh and the rack is positioned
as shown in
Figure 9.
6. Slide the table bracket and rack over the col-
umn. Let them slide down the column until the
bottom of the rack contacts the shoulder of the
column support.
7. Slide the column ring over the column with
the beveled edge facing down ( Figure 10), fit
the beveled edge of the column ring over the
rack, and tighten the set screw.
Note: Do not
over-tighten the set screw or you may split the
column ring. Also make sure the rack is seated
firmly in the lower ring.
8. Thread a clamp bolt into the non-threaded
side on the back of the table bracket about
three turns, for now.
Figure 11. Lock shoe installed.
Components and Hardware Needed: Qty
Headstock ..........................................................3
Lock Shoe ..........................................................1
Clamp Bolts .......................................................2
To install the column:
1. Insert the included lock shoe into the recessed
pocket on the inside of the headstock opening
as shown in
Figure 11.
Headstock
The headstock is a
heavy load. Seek assis-
tance before beginning
this step.
2. With the help of an assistant, lift the head-
stock over the top end of the column. When
the underside of the headstock is lined up
with the column, slide the headstock onto the
column until it stops (approximately 2").
9. Install the table support arm (G7946) onto the
column support arm, then install the table.
10. Thread a clamp bolt into the non-threaded
side on the table support arm and column
support arm about three turns for now.
Column
Support Arm
Handle
Set Screw
Lock Shoe
Rack