Grizzly G7945 - Manual (Page 30)

-28-
G7945/G7946 Radial Drill Press
Figure 24. Locating pin and nut (G7946).
2. Loosen the lock bolt (Figure 25) using the
included wrench and tilt the table (G7945)
or the column support arm (G7946) to the
desired angle.
Locating Pin Nut
Figure 26. Adjusting distance from column.
Figure 25. Angle adjustment bolt (G7945).
Clamp
Bolts
Table Rotation
(Note: The following steps only apply to the
G7946.)
1. Loosen the clamp bolt located under the table
26. Rotate the table the desired amount.
2. Always lock the table support arm in place
before operating the machine.
Distance from Column
(Note: The following steps only apply to the
G7946.)
1. Loosen the clamp bolt located at the pivoting
elbow of the table support ( Figure 26).
2. Swing the table support to the desired dis-
tance from the column. The support bracket
may need to be rotated around the column
to keep the table centered under the chuck.
Secure all clamp bolts before operating the
machine.
3. Lock in place by tightening the lock bolt.
4. To return the table to its original position,
align the holes in the column support arm and
the table bracket, insert the locating pin and
nut, and gently tap the pin with a hammer.
5. Tighten the nut.
Lock Bolt
Table Tilt
With the Model G7946, start at Step 1. With the
Model G7945 start at Step 2.
1. Turn the locating pin nut (Figure 24), in a
clockwise direction. This will draw the locat-
ing pin out of the casting. Once loose, pull out
the pin and nut, and set them in a safe place
until needed.