Stovax PM219 - Manual (Page 26)

26
INSTALLATION INSTRUCTIONS
8. FITTING AND REMOVAL OF
TRADITIONAL SPARKGUARD
16" 22" 24" 26" 28"
Traditional clip-in spark
guard -std
8690 8691 8692 8693 8694
Traditional clip-in spark
guard -low lintel
8695 8696 8697 8698 -
33
PR8095
Feet
Convector
box
channels
• Fit the sparkguard feet to the frame using fixings supplied
The longer side faces the convector box.
• Slide the spark guard feet under the convector box
channels
34
PR8096
Closed
• Rotate top clips to locate in behind Convector box flange
• Releasing the sparkguard is the reverse of the above
9. FITTING AND REMOVAL OF
CONTEMPORARY STEEL FRAME
SPARKGUARD
16" 22" 24" 26" 28"
Contemporary clip-in
spark guard
8740 8741 - 8743 -
35
PR8097
Sparkguard Feet
• Locate Sparkguard feet behind frame ledge
36
PR8098
Spring Clips
• Line up Spring clips with the internal edges of the frame
sides
• Secure in position by pushing on sparkguard handles
37
PR8099
• Adjust the top spring clips with pilers if required
Tighten enough to hold the sparkguard in position and pull
open easily.
Removal is the opposite of fitting:
• Pull lightly on the sparkguard handle to release spring
clips
• Angle towards you
• Lift the feet clear of the frame ledge