Golden Technologies ALANTE GP201SS - Manual (Page 16)

Alante´ GP201 Manual Revised 060208
16
ASSEMBLY Cont.
SEAT INSTALLATION
NOTE:
The seat assembly weighs approximately 24 lbs. without
armrests. Please ask for help if you do not feel capable of
safely lifting that much weight.
1. While holding the seat rotation lever (see Fig. 11) in the up
position, lift the seat and insert the seat post stem (located on the
bottom of the seat) into the seat-post. See Figure 10.
2. Swivel the seat from side to side, push down on it and release the
seat rotation lever until the seat locks in place.
Figure 10 Figure 11
LAP BELT INSTALLATION
1) Remove the two arm adjustment knobs (Figure 12).
2) Put the screw end of the arm adjustment knob through the
mounting hole in the latch side of the lap belt.
3) Screw the knob into the weld nut on the right side of the arm
mounting tube on the rear seat frame.
4) Put the other screw through the mounting hole of the buckle
side of the lap belt.
5) Screw the knob into the weld nut on the left side of the arm
mounting tube on the rear seat frame.
6) Once the arms are in place, tighten the knobs.
Figure 12
Seat Rotation Lever
Arm Adjustment Knob