Golden Technologies ALANTE GP201SS - Manual (Page 17)

Alante´ GP201 Manual Revised 060208
17
ASSEMBLY Cont.
ARM INSTALLATION
1) Loosen (but do not remove) the arm width adjustment knobs at
the rear of the seat frame.
2) Insert the lower arm tube into the arm receiver at the rear of
the seat frame. (Figure 13)
Figure 13
Be sure the arm pad is facing forward when the armrest is
in the down position.
3) Find a comfortable width and tighten the knob.
4) Repeat on the opposite side of the unit.
NOTE: When the arm adjustment knobs are tight, the lap belt
mounting plates will be free to move around the arm adjustment knobs.
JOYSTICK CONTROLLER INSTALLATION
1) With the seat installed and arms secured in place, slide the
joystick controller extension arm into the joystick controller
receiver. Fig. 13
2) Find a comfortable position for the joystick controller and secure
controller receiver.
Figure 14 Figure 15
Lower Arm Tube
Joystick
Controller
Receiver
Joystick
Controller
Extension
Arm