Golden Technologies ALANTE GP201SS - Manual (Page 19)

Alante´ GP201 Manual Revised 060208
19
DISASSEMBLY
Make certain that the joystick controller power is
turned off and that the chair is NOT in freewheel mode before
attempting to perform disassembly.
SEAT REMOVAL
1) Remove the Velcro ™ straps that secure the joystick controller cable.
(Fig. 16)
2) Remove the joystick controller by loosening the adjustment knob
under the joystick controller receiver. (Fig. 17) Slide the joystick
controller and extension arm forward and out of the receiver.
Carefully lay the joystick controller beside the power chair.
3) Fold the seat back down.
4) Remove the arms.
5) Lift and hold the seat rotation lever upwards to release the seat. (Fig.
11)
6) With the seat swivel lever held up, grasp the seat on both sides and
lift straight up. You may swivel the seat side to side to make the seat
easier to remove.
7) Carefully lift the shroud over the brake release levers and place on
side of Alanté (Fig. 7).
8) Disconnect joystick controller connections and feed connections
through the center hole in the shroud.
9) Unfasten Velcro® straps on batteries.
10) Disconnect battery cables from main wire harness.
11) Lift batteries out of the base and place on the side of the unit.