GCC Printers 2018 - Manual (Page 54)

Sending Scan Files by E-mail
48
4
Manual entry of a subject
A Select [Manual Input] using {{{{U U U U}}}}
or
{{{{T T T T}}}}, and then press the {{{{OK}}}}
key.
B Enter a subject, and then press
the
{{{{OK}}}} key.
The “ Accepted ” message ap-
pears, and then the Send Op-
tions screen returns.
Note
❒ When the subject to be en-
tered exceeds 64 characters,
“
U” appears.
Selecting a subject from the list
A Select [Select Programmed Sub-
ject] using
{{{{U U U U}}}} or {{{{T T T T}}}}, and then
press the
{{{{OK}}}} key.
B Select a subject using {{{{U U U U}}}} or
{{{{T T T T}}}}, and then press the {{{{OK}}}}
key.
The “ Accepted ” message ap-
pears, and then the Send Op-
tions screen returns.
JJJJ
Press the
{{{{Cancel}}}} key.
The initial scanner screen appears.
KKKK
Press the
{{{{Start}}}} key.
Note
❒ The original is scanned and the
“ Scanning... ” message ap-
pears.
• To interrupt scanning, press
the
{{{{Clear/Stop}}}} key.
❒ The scan file is sent and the
“ Sending... ” message ap-
pears.
• While sending a scan file,
you cannot do any other job.
• If sending fails, start the pro-
cedure again from the begin-
ning.